Amada Pega 357 User Manual Direct

The user manual places the highest priority on operator safety. Turret punch presses exert immense mechanical force and can cause severe injury if improperly managed. Daily Pre-Start Checklist

Always confirm that the stripper plate does not strike the clamp assembly. Program the machine using the correct dead zones (G70/G25 codes depending on configuration) to avoid punching the material clamps. 4. Routine Maintenance Schedules

Confirm the regulator reads within the safe operating zone.

The Amada Pega 357 relies on standard EIA/ISO G-codes. Below are the most frequent codes found in the manual. Primary G-Codes Rapid positioning (X, Y axes move at maximum speed). amada pega 357 user manual

The turret is divided into specific station sizes, usually designated by letters: 1/2" Maximum tool diameter B Stations: 1-1/4" Maximum tool diameter C Stations: 2" Maximum tool diameter D Stations: 3-1/2" Maximum tool diameter E Stations: 4-1/2" Maximum tool diameter Proper Tool Installation

rely on a scanned PDF that is missing fold-out schematics. The hydraulic and electrical diagrams are often double-page spreads. If your scan cuts off the right edge, you cannot trace circuits.

Measure the mechanical clutch and brake lining gap. If the lining wears down beyond the factory limit, the ram may drift or fail to stop at the top dead center (TDC). The user manual places the highest priority on

Demagnetized tools; incorrect die clearance; lack of oil on the material.

The Pega 357 is built for reliability, but some issues do arise. Your user manual will likely contain a troubleshooting section, and online forums are great for real-world solutions.

Ensure the main regulator reads between 5.0 and 6.0 kg/cm² (approx. 70–85 PSI). Low pressure causes clutch slippage. Program the machine using the correct dead zones

Align the punch key carefully with the turret keyway slot.

Clean metal shavings, check lubrication levels, and inspect tools for wear. GH Induction Weekly/Monthly: