Icom Ui7 Am Fm Unit Install

: Not required for the Icom IC-726 or IC-729, which often have these modes built-in. Installation Guide

: To protect the radio’s chassis from scratches while flipped over. Safety and Rig Preparation Power Down : Turn off the transceiver. icom ui7 am fm unit install

Enables the radio to be used for FM repeaters on the 10-meter band, especially when combined with the UT-20 Tone Encoder . Pre-Installation Requirements Before beginning, ensure you have the following: Icom UI-7 Unit Phillips Head Screwdriver (size #1 or #2) Static-Safe Work Surface (recommended) : Not required for the Icom IC-726 or

: Look for a designated open space on the main circuit board marked for optional units, featuring a multi-pin male or female connector header. Phase 3: Installing the UI-7 Module Enables the radio to be used for FM

Flip the radio upside down on your foam mat. Locate the screws securing the bottom cover of the transceiver. Remove these screws carefully and lift the bottom plate away to expose the Main Unit PCB (Printed Circuit Board). Step 2: Locate the UI-7 Mounting Position

Once the radio is fully reassembled, reconnect the DC power cable or AC power cord and attach an appropriate antenna to the receiver.

Remove the UI-7 AM/FM unit from its anti-static packaging, holding it strictly by the edges.