Caselabs Sma8 Manual Verified Jun 2026

If you have the optional motherboard slide-out track, mount the rails to the interior rear of the chassis frame. Slide the tray into place to ensure smooth movement, then secure it using the rear thumbscrews. Step 3.2: Flex-Bay (Front Drive) Installation

Many SMA8 cases were purchased with a pedestal—an additional modular base section. This pedestal is designed exclusively for massive liquid cooling setups. It can house another set of 480 or 560 radiators.

Once the mid-plate is in place, go back and fully tighten all the frame screws from Steps 2.1 and 2.2 to square the chassis. 3. Motherboard Tray and Drive Bay Installation

Assemble the case on a soft surface (like a large mousepad or towel) to avoid scratching the premium powder-coated aluminum finish. Step 1: Connect the Base and Vertical Supports Lay the bottom panel flat on your workspace.

Because the case arrives disassembled, you must first construct the internal skeleton. Lay out the top and bottom frame rails and secure the vertical support extrusions. : Do not fully tighten any screws until the frame is square. caselabs sma8 manual

Slide the PSU into the lower rear opening and secure the bracket to the chassis frame with four thumbscrews. Step 7: Wiring and Cable Routing

The lower compartment is a dedicated cooling playground, accessible via its own ventilated side doors.

Slide the entire radiator/bracket assembly back into the lower chamber. Secure it using the four corner thumbscrews.

: Attach the four vertical corner pillars to the bottom chamber floor using the provided 6-32 screws. The Mid-Plate If you have the optional motherboard slide-out track,

is an "end-game" chassis for enthusiasts who want zero compromises on space or build quality . While expensive and physically imposing, its ability to be completely dismantled and customized ensures it remains relevant across multiple hardware generations.

The Ultimate CaseLabs Magnum SMA8 Assembly and Customization Guide

If you find a PDF of the original SMA8 manual, please upload it to a public archive like [Archive.org]. With CaseLabs gone, you are now the custodian of history. Do not let the manual disappear.

Before diving into the mechanics of the manual, it is essential to understand why this case demands such a detailed guide. The CaseLabs SMA8, launched in January 2014, was designed as a "single wide" MAGNUM series case built for the highest of high-end builds. This pedestal is designed exclusively for massive liquid

Check that the entire frame is square. Use a carpenter's square if available, or visually align the edges. Once squared, tighten all frame screws firmly across the entire chassis starting from the bottom up. Internal Components Installation

arrives as a "flat-pack" or partially assembled kit, utilizing a Flex-Bay system that allows you to customize the front I/O and drive configurations. 2. Pre-Assembly Checklist Before starting your build, ensure you have the following:

If using the tech-station configuration, the tray can be used standalone outside the case for component testing. 4. Water Cooling Layout Options

Stand the front frame piece upright against the bottom floor panel. Secure it from underneath and from the inside using 6-32 x 1/4" screws. Do not tighten them completely yet; leave a small amount of play for alignment.

Assemble the core frame on a flat, stable surface. Do not fully torque the screws until the entire frame is squared.