How To Install Wilcom E2 In Windows 10 64 Bit Link -
Visit the official Thales (formerly SafeNet/Aladdin) sentinel customer support portal.
Windows 10 64-bit strictly blocks the installation of unsigned drivers. Wilcom e2 relies on older dongle drivers (like HASP) that Windows 10 will reject by default. You must temporarily disable this security feature. Click the and open Settings (the gear icon). Navigate to Update & Security > Recovery . Under the Advanced startup section, click Restart now .
When prompted to install the HASP driver, skip it or cancel that specific portion, as the version included with E2 is usually outdated for Windows 10. Configuring the Emulator and Drivers
Within your installation package, locate the CorelDraw X5 setup folder. How To Install Wilcom E2 In Windows 10 64 Bit LINK
Check the box for and select Windows 7 or Windows XP (Service Pack 3) . Check the box for Run this program as an administrator . Click Apply and then OK . Double-click the icon to launch Wilcom E2. Troubleshooting Common Errors "Security Device Not Found" (Error Code: H0007)
Are you using an or digital backup files?
Allow the CorelDraw installation to complete before letting the Wilcom wizard finish its final steps. Restart your computer when prompted. Step 4: Configure Hardware Lock / Dongle Emulation You must temporarily disable this security feature
Proper preparation reduces the risk of installation errors. Follow these preliminary steps:
If installing Wilcom e2 proves too difficult, consider these options:
Legacy Wilcom software requires communication with a security dongle. On 64-bit systems, this must be emulated using compatible 64-bit drivers. Under the Advanced startup section, click Restart now
Proceed through the installation wizard. When asked for a hardware dongle, skip or proceed past the prompt as instructed by your specific installation package files.
Open the Command Prompt (CMD) as an Administrator and run the command: bcdedit -set testsigning on Restart your computer after this step. Install Security Drivers: Navigate to your installation folder and locate the HASP Driver (often found in a folder named 01 HASP driver ). Run the HASPUserSetup.exe Install HASP Emulator:
: Double-click Setup.exe and follow the instructions provided by the installation wizard.
Upgrade to the latest version of Wilcom, which supports Windows 10 natively without emulation.
Wait for the installation wizard to copy the software files to your hard drive.