The XTA-7000 offers auto-tuning to adapt to the thermal characteristics of your system. Auto-Tuning (AT) Set your desired temperature.
Verdict (short)
| | Alarm Mode | Action | |----------|-----------------------------------|--------------------------------------------------------------| | 0 | No alarm | Disabled | | 1 | High absolute alarm | Activates if PV > AL1 (e.g., over-temperature protection) | | 2 | Low absolute alarm | Activates if PV < AL1 | | 3 | Deviation high alarm (relative) | Activates if PV > SV + AL1 | | 4 | Deviation low alarm | Activates if PV < SV - AL1 | | 5 | Heater break alarm | Requires optional CT (current transformer) input | xta-7000 temperature controller manual
Supports multiple thermocouples (TC) and RTDs (e.g., Pt100) or standard linear signals (current/voltage). Output Options: Relay Output: Contact capacity 250VA (resistance load). Voltage Pulse Output: (suitable for Solid State Relays - SSR).
Tighten the screws evenly until the controller is securely flush against the panel gasket. Terminal Configuration The XTA-7000 offers auto-tuning to adapt to the
The XTA-7000 temperature controller is a powerful tool, but its full potential is unlocked only by understanding its parameters. Keep this article as your quick-reference manual, always remember to for any new thermal system, and monitor the alarm outputs for safety.
Slide the included mounting brackets into the slots on the top and bottom of the housing. a plastic injection molding machine
Accessing advanced menus requires holding the key for 5 seconds and entering the default password bypass code ( 0001 or 0088 ).
Whether you’re setting up a new temperature control system for a heat-treating oven, a plastic injection molding machine, a laboratory incubator, or a food processing line, having a clear and comprehensive understanding of the XTA-7000’s functionality is critical for achieving precise, stable, and reliable temperature management.
XTA-7000 BACK PANEL WIRING TERMINALS (Typical) +-----------------------------------------+ | (1) AC Power (L) (7) ALARM 1 | | (2) AC Power (N) (8) ALARM COM | | (3) Output (+) (9) TC / RTD A | | (4) Output (-) (10) RTD B | | (5) NC (11) RTD B' | | (6) Ground (12) Shield | +-----------------------------------------+ Step-by-Step Wiring
: Sets the type of input probe (e.g., 0 for K-type, 21 for Pt100).