is a free, open-source radio programming tool supported by a large community. It is extremely popular among hobbyists for programming many different radio brands.
The cable plugs into the PC's USB port and connects to the Speaker/Microphone (SP/MIC) jack on the top/side of the IC-V80.
This almost always happens because the USB driver was installed incorrectly. Ensure you unplugged the cable, installed the driver first, restarted your PC if needed, and then plugged the cable into the radio.
Icom IC‑V80 is a handheld VHF transceiver commonly used by amateur radio operators. Programming software lets you configure frequencies, channels, tones, and other settings from a PC for faster, error‑free setup.
Once the progress bar completes, you will see a spreadsheet-like grid representing your radio's memory channels. Editing Frequencies and Settings Icom Ic-v80 Programming Software Download
: Edit memory channels, configure power levels, and store backup radio configurations on your PC. Where to find it : Detailed product information is available on the Icom Japan CS-V80 page
Follow the on-screen prompts to complete the installation.
18;write_to_target_document1a;_k2zuaaLeD92sw8cP6aHYyQI_20;679; Whether you choose the official Icom CS-V80 18;write_to_target_document7;default0;1e2;
You cannot download it. The software must be purchased physically on CD-ROM from an authorized Icom dealer or retailer. is a free, open-source radio programming tool supported
Install from the provided CD or download link after purchasing. 2. Install the Cable Driver
To use the Icom IC-V80 programming software, follow these steps:
. Note that while listed as an option, Icom often distributes this software through authorized dealers rather than as a direct free download from their main support site. Icom America Alternative: RT Systems WCS-V80 Many users prefer the RT Systems WCS-V80 software
The Icom IC-V80 is a legendary, rugged VHF handheld transceiver favored by amateur radio operators, emergency responders, and outdoor enthusiasts worldwide. While you can program frequencies manually using the keypad, utilizing dedicated software is the fastest way to manage channels, set up repeaters, and configure advanced settings. This almost always happens because the USB driver
You need a cable with a USB plug on one end and a 3.5mm (1-pin) jack on the other.
If you have purchased the software or want to download the official USB cloning cable drivers, follow these steps:
: Fill in your frequencies, names, and offset shifts.
Turn your IC-V80 OFF , plug in the 3.5mm jack, and then turn the radio ON . 📝 Programming Steps
To use the software, you must purchase one of Icom's optional programming cables separately: