360 Manual: Wittmann Tempro Plus D

Includes automatic filling, constant pressure monitoring, and automatic pump rotation detection. Standard Procedures and Maintenance 1. Logging In

is a versatile and robust controller. By following the operating procedures outlined in the official Wittmann manual, operators can maximize the service life of the unit and ensure superior mold temperature control.

Clean the cooling water inlet filters to prevent scaling and flow restrictions.

Reduces energy consumption by lowering pump speed to 30% and setting a temperature offset of -20°C from the setpoint. Reactivates automatically after 30 minutes or upon touch.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

Ensure the flow rate is adequate for your mold design. Maintenance and Troubleshooting Routine maintenance is covered extensively in the Wittmann Tempro Plus D 360 manual

Typically ranges from 9 kW to 36 kW depending on the specific model variant.

| Description | Wittmann Order Code | |-------------|----------------------| | Heater cartridge, 3 kW, 230V | 435.102 | | Pump mechanical seal (for Grundfos CM-3) | 427.981 | | Flow sensor (turbine, 2–60 L/min) | 528.045 | | Touchscreen display assembly | 710.899 | | Solenoid valve coil (direct cooling, 24V DC) | 392.332 | | Pressure relief valve, 12 bar | 204.776 |

In the world of precision injection molding, temperature control is not just a parameter—it is the backbone of product quality, cycle time consistency, and energy efficiency. Among the industry’s gold standards for mold temperature control units (TCUs), the stands out as a robust, high-performance machine designed for demanding applications.

Regular maintenance is crucial to ensure the device operates correctly and safely. Follow these guidelines:

: In the "Service" tab under the "121 times" menu, you can set the "first filling max field" to ensure the unit primes correctly. 2. Core Operation Features