Wire the open collector output to the relay coil or access control strike (ensure you utilize a flyback diode on the relay coil to protect the TS1162's PCB from inductive voltage spikes). 💻 Panel Programming and Configuration
Connect a Category 6 (Cat6) Ethernet cable to the RJ-45 management port. This allows direct browser-based access to the drive’s internal operating metrics.
On the Challenger controller, you must define the keypad's role. This is done via the system's programming software. Refer to the table below for the correct model selection: ts1162 installation manual exclusive
Align the TS1162 drive cradle with the targeted library bay guide pins.
I can provide the exact software configuration scripts or zoning commands for your setup. Share public link Wire the open collector output to the relay
I can easily update the technical steps or diagrams based on your specific system details.
: Connect to the 12VDC auxiliary power supply rails coming from the Challenger panel. Ground (GND) : Pair directly to the reference system ground. On the Challenger controller, you must define the
| Problem | Likely Cause | Solution | | :--- | :--- | :--- | | | Power not reaching the timer motor. | Check Line voltage. Ensure wires are connected to the correct Line terminals. | | Load does not turn on | Trippers are loose or missing. | Tighten tripper screws. Verify trippers are installed at the correct times. | | Switch stays ON constantly | Manual Override is engaged. | Move manual override switch to the "Auto" or center position. | | Switch hums loudly | Loose mounting or internal wear. | Ensure the unit is screwed tightly to the box. If noise persists, mechanism may need replacement. |
A: Yes, the TS1162 is , making it weather-resistant and suitable for outdoor mounting.
This exclusive technical guide consolidates wiring instructions, hardware specifications, programming steps, and diagnostic procedures to ensure successful commercial installation. 1. Technical Specifications Reference