Fix Ml1660 V1.01.00.30.fls Guide

A command prompt (DOS) window will appear, showing the progress of data being sent to the printer.

Since the error specifically complains about version 1.01.00.30, you need to re-flash exactly that version. Newer firmware might not work.

A power surge while the printer is in sleep mode can corrupt volatile memory. Although rare, this can scramble a single .fls file without physically destroying the board. Fix Ml1660 V1.01.00.30.fls

caused by non-original or refilled cartridges.

If FloTool shows “Timeout error” or “No response from device,” repeat steps 5–7. Timing is critical. A command prompt (DOS) window will appear, showing

Like most entry-level laser printers, the Samsung ML-1660 and its siblings (like the ML-1665) use smart chips on the toner cartridge. These chips track the number of pages printed and forcefully disable printing once the page threshold is reached, even if the cartridge still contains usable toner powder.

Look for the line labeled . It must match V1.01.00.30 exactly for this specific file to work. How to Install the Fix A power surge while the printer is in

A small command prompt window will open, showing a progress bar or a series of dots indicating data transmission.

The window will close automatically once the data is sent. Step 4: Wait for the Reboot

If the first three methods fail, the NAND flash chip is physically damaged. You cannot "fix" a dead sector in firmware – you must replace the hardware.