Canon Service Mode Tool Version 1.050 !exclusive! (FHD 2025)

Disconnect the power cord, restart the computer, and repeat the hardware key sequence to re-enter Service Mode. Important Safety and Legal Guidelines

: Execute technical test patterns to verify print head health and alignment beyond standard user menus. Operational Protocol

A user on a printer forum correctly explains the distinction: "Service Mode" is a special state inside your printer that you can activate with a button sequence. The "Service Tool" is the separate software that allows you to alter information on the printer's memory chip while it is in that service mode. They work in tandem.

: The software will automatically scan the USB ports for an active Service Mode device. Canon service mode tool version 1.050

: Enables changing the printer's internal region code (e.g., for compatibility with different cartridge regions). Canon Community System Requirements & Compatibility Operating System

Press the Stop/Reset button exactly 5 times. The LED indicator will alternate between green and orange with each press. Release Power: Let go of the Power button.

Let go of the Stop/Reset button while keeping the Power button held down. Disconnect the power cord, restart the computer, and

Version 1.050 is a legacy version. It was specifically engineered to support Canon models released around the late 2000s and early 2010s. Using it on modern MegaTank (G-Series) or modern TS-series printers will fail or cause damage.

The Service Mode Tool will not detect your printer under normal operating conditions. You must manually force the printer into Service Mode using a specific hardware key combination.

: Clears the internal "absorber full" error (often indicated by error code ), allowing the printer to continue operating. Error Management The "Service Tool" is the separate software that

. The green light should blink and then stay lit, indicating it is in Service Mode. Where to Use the Tool Official Maintenance: For most users, Canon recommends using the IJ Printer Assistant Tool

| Tool Version | Release Date | Key Features / Changes | |--------------|----------------------|--------------------------------------------------------------------------------------------------| | | June 22, 2009 | Initial support for "2009 2H models". Added functions to print Nozzle Check and Inspection patterns. | | v1.074 | Post v1.050 | Required for upgrading from v1.050. Support for 2008 2H and later models. | | v2.000 | Post v1.074 | Support for "2010 2H models". New two-sheet dialog. Removed EEPROM reset function to prevent misuse. | | v3.400 | February 23, 2012 | Support for 2012 1H & 2H models. Marked a shift in compatibility to newer cartridge generations. | | v4.718 | July 31, 2015 | Support for 2015 2H models. Added a new "Pro" tab to the interface. | | v5.103 | November 27, 2017 | Support for later 2017 models. Continuation of the 5xxx series for modern PIXMA printers. | | v6.000+ | 2022+ | Latest iterations (e.g., v6000) with support for a wide range of modern E, G, TS, and TR series printers. |

Locate the Ink Counter section, select Main , and click Set again.

Compatibility and requirements

: While holding Power , press the Stop button exactly 5 or 6 times (the exact number depends strictly on your specific Canon model). The alarm LED will flash with each press.